Categories

Electronic creaser heads
Brand: LCP
Product Code: Electronic creaser heads
Availability: In Stock
Price: $10.00

Available Options


* Electronic creaser heads:



































Qty:     - OR -   Add to Wish List
Add to Compare

You can have the electornic creasers here: http://www.leathercraftpattern.com/electronic-leathercraft-creaser

Electronic creaser heads

 

F series pictures

F series are mainly for making decoration lines, the line width is about 0.5mm

※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※

E series pictures

E series are mainly making round edge with decoration line

※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※

S series pictures

S series are mainly for iron the edge oil and making decoration lines on some hard reach places

※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※

L series pictures

L series are mainly for pressing the edge down to make the bulge effect

※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※

FN series pictures

FN series have same function as E series, but the decoration line width is 1mm

It was designed with a cutting corner, that will be easier for dealing with inner curved places

※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※

FNR series pictures

FNR series is a special version for FN series, it is round shape, so very easy for making shoes

※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※

Special head pictures

Special heads are mainly used for special purpose:

No.1 is wax knife - iron bee wax on the edge (integrate with heater)

No.2 is iron - iron the crumpled leather smooth or iron the flesh side with tragacanth (integrate with heater)

No.3 is slicker - iron a smooth edge 3mm and 4mm

No.4 is slicker - 5mm and 6mm

No.5 is watch belt iron - iron the hole for spring bar

No.6 is thread burner - burn the thread

No.7 is seperated heater - it works with No.3, No.4, No.5, No.6

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: