With instruction - Laser cut Acrylic template, cigar case pattern, A-138

Here is the instruction online: https://www.instructables.com/id/Cigar-Case

We developed some Acrylic templates, by using it, you no need to draw lines on the leather, just use knife to cut leather directly, save you some time.

But we should admit that acrylic pattern is not as detailed as downloadable pattern, downloadable pattern has more hits on it. But the instruction will help you.

We use 2.0mm acrylic board, after lots of test, 2.0mm is the best thickness.

For this pattern:

The finished size is about: 2.4" x 3.9" x 1.2" (6.2cm x 10cm x 3cm).

Advice:

Hardware: 201 snap x1.

Leather: We advice 2.0mm (5oz) leather 30cm x 10cm.

Notice:

If there is no in store, we normally need 2-3 days to product, please be patient, thank you!